Rawhide Strips For Viking Reenactment Shield Edging

Rawhide Strips Made From Dried Deer Skin, Sold in Various lengths for Viking Reenactment Shields.

Use our rawhide strips for your shield edging. To use then place the rawhide in a bucket of water and wait until it it soft enough to work with. Stretch the rawhide around your shield edge and leave to dry, ensuring you have equal overlap at both sides. Once dry then you can drill holes and attach with our rivets, or use thick leather thong if you want it stitched.

– All strips are approximately 45 – 50mm (1.75 – 2 inch) wide and 1 – 2mm thick.
– Prices are per roll.
– To work out how much you need then it will be 3.141 x shield diameter.
– Common shield sizes are 28, 30 & 32 inch (71, 76 & 81cm), so rawhide required for your shield, to allow for a bit of overlap:
– 28 inch (71cm) shield = 230cm.
– 30 inch (76cm) shield = 245cm.
– 32 inch (81cm) shield = 260cm.

– To use, soak in cold water until it is wet and pliable.
– Once soaked and ready to use then mould the rawhide along your shield edge.
– Once dried on your shield edge then make the holes you require to rivet / stitch the rawhide on.